Is there any way to do this without hot-swapping the cart?
The manual specifically warns against removing or inserting the cart when the Saturn is powered on.
I think all of the methods mentioned above would require a hot-swap?
Anyone got any experience using one of these kits?
I am having trouble getting a connection between the host and the target.
I am not sure if I have selected the correct DMA or IRQ settings.
The ISA board does not seem to have any labels by the dip switches, so I am not sure if the jumpers are in the correct positions.
I am also running Win98 SE, not sure if that is an issue since most of the tools are dos or Win95.
When I try to install the Psybios file I get a message saying:
"PSYBIOS version 1.23"
"Installed OK - card address 318, DMA channel 7, Interrupt 15"
I power the console on and it boots to the PSYQ splash screen.
But when I try to execute the Run application from a dos command prompt I get a message saying "Cannot connect to target".
I also get a similar message when launching the PSYQ Win95 debugger.
I have tried different combinations of IRQ and DMA with the same result each time.
I am also not sure if I am using the correct cable.
The ISA board is labelled SCSI and the PSYQ cart is labelled SCSI2, but both devices have DB25 ports.
I am just using a standard male-male DB25 cable.
One thing that I did notice is that the PSYQ manual says that booting or resetting the console whilst holding down the start button on the controller will cause the cart firmware to print it's current config and self-test results on screen.
But when I try this with the controller in either port it just boots to the PSYQ splash screen without printing anything.